In this section
@article{Correa:2018:10.1016/j.medengphy.2018.09.006,
author = {Correa, T and Pal, B and van, Arkel R and Vanacore, F and Amis, AA},
doi = {10.1016/j.medengphy.2018.09.006},
journal = {Medical Engineering and Physics},
pages = {22--28},
title = {Reduced tibial strain-shielding with extraosseous total knee arthroplasty revision system},
url = {http://dx.doi.org/10.1016/j.medengphy.2018.09.006},
volume = {62},
year = {2018}
}
TY - JOUR
AB - BackgroundRevision total knee arthroplasty (RTKA) has poorer results than primary total knee arthroplasty (TKA), and the prostheses are invasive and cause strain-shielding of the bones near the knee. This paper describes an RTKA system with extracortical fixation. It was hypothesised that this would reduce strain-shielding compared with intramedullary fixation.MethodsTwelve replica tibiae were prepared for full-field optical surface strain analysis. They were either left intact, implanted with RTKA components with cemented intramedullary fixation stems, or implanted with a novel design with a tibial tray subframe supported by two extracortical fixation plates and screw fixation. They were loaded to simulate peak walking and stair climbing loads and the surface strains were measured using digital image correlation. The measurements were validated with strain gauge rosettes.ResultsCompared to the intact bone model, extracortical fixation reduced surface strain-shielding by half versus intramedullary fixation. For all load cases and bone regions examined, the extracortical implant shielded 8–27% of bone strain, whereas the intramedullary component shielded 37–56%.ConclusionsThe new fixation design, which offers less bone destruction than conventional RTKA, also reduced strain-shielding. Clinically, this design may allow greater rebuilding of bone loss, and should increase long-term fixation.
AU - Correa,T
AU - Pal,B
AU - van,Arkel R
AU - Vanacore,F
AU - Amis,AA
DO - 10.1016/j.medengphy.2018.09.006
EP - 28
PY - 2018///
SN - 1350-4533
SP - 22
TI - Reduced tibial strain-shielding with extraosseous total knee arthroplasty revision system
T2 - Medical Engineering and Physics
UR - http://dx.doi.org/10.1016/j.medengphy.2018.09.006
UR - http://hdl.handle.net/10044/1/65182
VL - 62
ER -
The Biomechanics Group
Mechanical Engineering
Imperial College London
South Kensington Campus
City & Guilds Building
Exhibition Road
London SW7 2AZ
+44 (0) 20 7589 5111